9095-10110-115 Gas PermASeal

9095-10110-115 Gas PermASeal

Gas PermASeal (115mm wide rolls)

An opaque, non-woven porous and gas permeable film which acts as a barrier to solid contaminants. It seals to Polypropylene and Polystyrene plates. The seal is pierceable and peelable, and not certified free from nucleases and DNA.

9095-10110-115LRGas PermASeal200M x 115mm
9095-10110-115SRGas PermASeal - Sterile200M x 115mm
9095-10110-115TRGas PermASeal5M x 115mm

Polypropylene (PP), Polystyrene (PS).

Short term incubation, agriculture and seed storage, insect storage, cell culture.

Store in a cool place. Avoid direct exposure to sunlight. It is recommended to use the seals within three years from date of purchase. Three years when stored at 21℃ (70℉), 50% relative humidity, out of direct sunlight, in original packaging.

Temperature range -20℃ to 80℃

Temperature and Dwell Time: 170℃, 2 seconds.
Recommended sealing equipment: Ultraseal Lite / PRO / XT PRO / ePRO, Wasp, Chameleon, Kube, ALPS3000/5000, A4S, PlateLoc.

Visual Description

White non-woven. Seal side has a shiny lacquer coating.

Physical Properties
Temperature Range: -20℃ to +80℃. Compatibility: Polypropylene (PP), Polystyrene (PS).

Mass Loss

Confirming the materials ability to resist high temperatures. Results: N/A.
Details: Mass loss of solution evaluated after 30 cycles of 3 step PCR Programme. Equipment: ABI Thermocycler, Precision Balance.

Measuring the force required to push a standardised needle through the material via compression measuring equipment. Results: Pass.
Details 5 tests run using a standardised needle, ensuring that less than 10N is required to pierce the surface & access the wells. Equipment Instron 3343 Tensometer.

Determining the materials optical clarity by measuring the transmission of emissive dye through the material. Results N/A.
Details Record the light transmission of a sealed microplate using a Flurophore dye stock solution and a microplate reader. Equipment BMG Labtech - FluroStar.

Measuring the materials permanence of adhesion & its ability to be removed, via extension measuring equipment. Results: Pass.
Details Cohesive Failure, Adhesive Transfer, Material tear & Successful Peel are measured & recorded after a 180℃ peel test. Equipment Instron 3343 Tensometer.

Water Vapour Transmission
Confirming the materials ability to breath. Results: Pass.
Details: Measure the weight loss of water during a set time at a set temperature and humidity Test Method: T30/001, Ref ASTM E-96-66, Target: 1800 g/m2/24h.

Evaluating the materials resistance to solvents (DMSO used as an aggressive standard). Results: Pass.
Details: Sealed plate is subjected to a high concentration of DMSO for a time period at low temperatures after which seal damage & volume loss are determined. Equipment Laboratory Cold storage unit, DMSO solution.

Plate Types, Sealing Temp. Time Settings
Polypropylene(PP), Polystyrene (PS).
Temperature and Dwell Time: 160℃, 2 seconds.

QC testing is carried out to ensure that products are free from nucleases (DNases & RNases) as well as human genomic DNA. Although every effort is made, including cleanroom manufacture, to maintain this level of cleanliness, best laboratory practice with regards to duplicate testing should be followed.

Kbio back button